Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
qpsk: need help please.
hello,
In my code for qpsk i have passed the input signal through an fir filter having 6 coefficients.. the i/p signal was convolved with h(n). this leads to degradation of the signal.
Now i have been asked to remove the effect of this channel on the performance...
hi there,
i had mentioned earlier that i had done a tx n rx system simulatin qpsk system. i got the BER curve perfectly. my next task was to have the qpsk signal pass thru an FIR filter. I did that as well. and as expected the signal underwent distortion.
now i have been asked to the following...
i'm being asked to pass through the filter so that i can notice the difference.
the entire task is to pass the qpsk signal through the filter and then add noise to it.
hi.
I have written a code which emulates a qpsk tx n rx system. it works perfectly and i'm getting the BER curve exactly.
As my next task i have been asked to design an fir low pass filter through which i am to pass the qpsk signal. i'm not getting much assistance from the guide and i'm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.