Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It is not easy to say the ground in singnal layers good or not. If you done well layout, it will be much benefit, if not, it will be nightmare.
For a 8-layers board with only one ground and power layers, it is truely bad.
best psb layout software
As my experience, for a starter, Protel is much easier. for a mass production products and design with a big team, mentor expedition is the best. for schematic, OrCAD capture is the most friendly one, the problem is transfer one schematic from OrCAD to mentor always not...
Where can I get some article about ferrite in EMC suppress, I need used some ferrite in my design to suppress the radiation from 30~300MHz, especially in 30~40MHz and 247MHz around
thanks!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.