Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
goxy
Thanks for your answer
But the filter that I design include tuning and coupling screw, so more parameters need to be determined,and if use crosscoupling then how to do?
cavity filters, cst
For cavity filter design, now we only first simulate single cavity's resonance frequency, then caculate the coupling coefficient that determine the ires'width.
I have seen some papers that introduce full cavity filter simulation using HFSS and CST,but I can't grasp the main...
rod cavity filter designer free
CST is the better software to simulate the cavity filter,but for filter synthesis, you should write synthesis program by yourself,you can refer to Cameron's paper in MTT.
I desigened a duplexer(2 passband filters), but the interference(in Rx path, in Tx frequency band it generate a sharp peak and in Tx path in Rx frequency band it generate a sharp peak ) between Tx path and Rx path is much big, I use the ADS to simulae, also got that interference, so how to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
