Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the responses.
The oscilloscope shows around 2x the value (not exact) I set on the pulse generator as pointed out above by Milad-D.
My doubt is, the oscilloscope input impedance might be different from my circuit input impedance, so how should I ensure precise voltage levels up to...
Dear Experts,
I have one 10MHz pulse generator with 50 ohms source impedance.
I need to drive a MOS circuit with this pulse generator.
The user manual for pulse generator says specification valid only for 50 ohms load.
My application needs precise voltage values at the input. What should I do...
Re: mmsim 6.1
I am trying to run Cadence and Simulink Co simulation using the SimCoupler module provided in the cadence amsdMatSim tutorial.
However the .mex files provided in this tutorial does not match my linux version.
Does anyone know the source to SimCoupler.c file?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
