Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by shabbs

  1. S

    mini-sub D connector for the PCB

    Hai ! Iam looking for a mini-sub D connector for the PCB ,rather than attaching a female Mini SUB D .I would like to connect it to wire due to space constraint.If you have any conncetor with this specification then kindly let me know.I would welcome any suggetion. With regards Shabbir
  2. S

    PCB design Help needed !- division, verifiying the shematic

    dsn pcb design format Hi , Iam new to PCB design,I have a big schematic diagram -How can i make division,I mean make indivudual circuits and connect one with the other ? -How can i verifiy the shematic is working properly.Where shall I start(I do have Idea that I need to Simulate using SPICE)...
  3. S

    USB 2.0 HUB repeater notes

    Re: USB HUB could u pls send me about USB at shabbs2shabbir@gmail.com
  4. S

    Declaring a variable as output in two different modules in Verilog

    Re: verilog doubt Hi ! Assuming module m3 works from the output of either module m1 and m2.I think its absolutely possible to put the output of m1 or m2 ans input to m3.make sure to declare the m3 port as bidirectional port
  5. S

    Binary inputs - Principles of Modern Digital Design

    Binary inputs 1,0,X,Z Hai there ! In real world of digital system Its either 1 or 0 volts(0-1volts) for 0 and ( 2-3volts) for on.How could a digital system have x,z.X is unknow state but a sytem should have finite value. I mean if one doest knows the value then how could he predict the systems...
  6. S

    What to do with the unconnected port(input or output)?

    Unconnected Ports Hai there ! Thanks for reading this post.I have query that,What should one do with the unconnected port ( input or output ).Is it ok to leave it open else if we ground it or put high value .Later in the design while using the same port.Wouldnt the output have error ?
  7. S

    simulating using COMSOL .THE EFFECT OF EMBEDDING A RESONATOR

    waveguide resonator comsol Iam desiging a Ciculator, simulating using COMSOL .the project is about the EFFECT OF EMBEDDING A RESONATOR IN A RE-ENTRANT WAVEGUIDE CIRCULATOR.I dont where to start with ? can anyone pls tell me if there are any previous research papers regarding deigning of a...
See more

Part and Inventory Search

Back
Top