Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I disgned 128b/132b encoder and decoder block in verilog code but my data width is 8 bit and my encoder' s input in 128 bit so how can I communicate my data bus with encoder?how can this encoder get 16 8 bit symbol?
Hi
I want to design 128b/132b encoder and decoder.I got the verilog codes for 64b/66b encoding system but I dont know how should I use it for 128b/132b? Do you have the verilog code for 128b/132b?If no, please help me to write the codes
I should design scramblar and unscrambler blocks for my project
I have scrambler's block diagram and verilog code but I don't know what should I do about unscrambler block?Is its block diargram and verilog code the same as scrambler's?
I want to use the newest version of usb module so I choosed USB 3.1 If it can't be used in a microcontroller I should change the version of USB
Are you sure the microcontroller is not able to use USB3.1 data rate?
being low power is important I mean certain amount of current is not important but...
My thesis for master's degree is designing a low power usb module to use in a microcontroller in cmos process
I must design a usb 3.1 module but I don't know what should I do to have a low power usb module.Amount of current is not important
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
