Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
gerber silkscreen image
Instead of using Gerber Tools, It is better to import the Gerber File in Your PCB Editor software.Delete the unwanted part(I hope u can select and delete).Then convert the bmp file into PCB format or Gerber format using some free standard tools available.Import the same...
What P*otel files needed to send for fabrication and assembl
Normally for the PCB Fabrication you require the Gerber Files of each and every layer you used in your Layout, the NC Drill File which contains the hole dimensions and the coordinates.In addition to these you may require the assembly...
dxp2004 global change
Just press F11 when you have selected your tracks. This will start the inspector which will give you the option to change values for parameters such as track width etc. These changes will apply to all selected objects.Do the same for pads or vias, make sure only pads or...
You please convert the PCB File into Gerber Format.In the Gerber Text File Please add the following two lines after second line of the gerber file
%IPNEG*%
%LPC*%
These two are for converting the Gerber into negative.Now open this gerber file in a gerber viewer, probably your PCB Design...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
