Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello.
I want to simulate microstrip line in the HFSS. The line has a gap wich has the Schottky diode soldered into it. I want to place lumped ports in the places of the diode connection, and then transfer solution to the Designer for perfoming non-liner simulation.
But I doesn't know how to...
Ok, if I draw graph of
angl*mag(S(FloquetPort1:1,FloquetPort2:1)) + (1 - angl)*mag(S(FloquetPort1:2,FloquetPort2:2))
for example agnl = 0.5 for 45 degrees
Will it correct?
Yes!
So, how I understand, when I have solved first two modes with ortoganal polarization, I can get solution at different angel, right? But, if it's true, how to build a graph of S12 for that angel?
Hi.
I have a task to research how the polarization angle effect on the frequency selective surface.
In current model I use the Floquet ports with Master-Slave BC on the square boundaries, but I don't know how turn polarization of 0,1 modes of the floquet port.
Or, may be, there is a way to use...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
