Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI ,
i want to add an inductor to my circuit using cadence , when i add after that for 35mH i dont know how to set the parameters.
Like when i press object prperties it shows inner radius inner width and number of turns , i dont know exactly how to match it for 35mH with this...
thanks dude,
really it was helpfull, i got the current as 38mA for output voltage of 9V and input dc is 4V.
i want to know whether the answer is nearly correct atleast.
thank u so much for your reply
i have attached my screeen shot of out voltage and gain
when i try to plot output , steps i followed
>result>direct plot>main form >current>add plot >select on schematic ?two nodes which are output and grnd.
but error.
is there any other method to find current...
hi i need help regarding find power dissipation for Op amp design my design using cadence tool.ihave got output voltage .i dont know how tp proceed next.i tried doing in calculator option but it pop up error.
can u help me in steps
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
