Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Ya i have refereed SPI specification before writing the program. Based on SRAM timing requirement i developed my code like as follows and please what are the wrong in my code and if any changes is there please give me the solution.
1. Enabled GPIO pin as MOSI, MISO, CLK, CS
2...
Hi i am interfacing 256SRAM (N25S830HA) to LM3S3748 controller using non spi port that means gpio port. Here i have to write spi driver using gpio pin (not inbuilt spi port). I have written code but after finishing writing then i will start to read then only 0 value coming. So i want to know...
Re: GPRS Progran in LPC2129
yes sir i got OK reply from modem. But i am getting confusion in AT+CGDCONT = 1,"IP","internet.gprs"," command. Also sending message to internet.
If you have working code send me..
With regards,
Seetaram
Re: GPRS Progran in LPC2129
I have two modem
1) M23A GPRS modem
2) Wavecom Modem
I am trying in both modem. You can send any modem code.
Please reply me fast
lpc2129
Hi,
This is Seetaram i am developing one project in LPC2129 in that i am using GPRS to send information to internet. Here i am not getting the idea to program to this GPRS by using AT command.
AT+CGDCONT = 1,"IP","internet.gprs","0.0.0.0",0,0<cr>(1-GPRS context setting)
In this...
programy lpc2129
Hi,
This is Seetaram i am developing one project in LPC2129 in that i am using GPRS to send information to internet. Here i am not getting the idea to program to this GPRS by using AT command.
AT+CGDCONT = 1,"IP","internet.gprs","0.0.0.0",0,0<cr>(1-GPRS context setting)
In...
can program for lpc2129
Here i am developing one project using LPC2129 controller in this project i am using stepper motor. So i wrote code for this stepper motor but its not working correctly.
if anyone have this program please send me.
Thanking you.\]
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.