Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: problem in t6963c with 8051
hello sir i am using external character mode ( i.e all the 256 byte of character generator area is user defined )during interfacing t6963c ic compatible glcd with mcu
but during the interfacing all the character code i have generated are displaying unwantedly...
Re: problem in t6963c with 8051
sry sir
for repeating my message
sir since i have used development board and connected glcd externally that's why i have provided only glcd connection with mcu
sry for the declaration of port1 and scematic
sir i am sending the modified code again...
Re: problem in t6963c with 8051
SIR THIS IS MY CODE
NOW CAN U PLEASE TELL ME WHAT MISTAKE I HAVE DONE,FOR WHICH MY DATA IS NOT DISPLAYING
//////////////////SYMBOL DECLARATION///////////////////////////////////////////////////
RESET BIT P1.0...
hello i am interfacing t6963c with at89s52 with external character mode (value is 88h)
using display mode text on ,graphic off,cursor off(value 94h)
all the control pins except fs (fs is grounded) i am controlling through software
for contrast control i have connected one pin of variable...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.