Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear All,
I am working as a PCB DESIGN ENGINEER in chennai. I want to some extra work at home so i need some pcb designing work.
Pls let me know if u have any information about this.
schematic file viewing software
Hello pranaam77,
Hello mandar_mahajan,
The .sch file is supported by Express PCB software.
Thanks for your useful comments.
.sch file
Hello Everybody,
I have some schematic file. like the file is: Distribution board.sch
i have to open the schematic file.
But i dont know which software can support .sch file.
If anyone know about the .sch file supporting software, kindly let me know.
Thanks & Regards,
Sankar.
lyt file
Hello Friends,
I am working as a PCB Designer with EXPEDITION PCB.
I have some clarification about PCB File.
I had done one 4 Layer PCB few month ago. while that time i opened the pcb. its opened. Recently i have try to open. But i couldn't open. there is appear error message. The...
how to open *.sbk schematic
Hai Every body,
This is sankar. i have used MENTOR EXPEDITION PCB software.
I have some doubt.
first i did one PCB. there is no problem. after we went to next version. there is little bit only changes in schematic. so i changed the modification.
Even i...
Thanks for your reply.
But sorry i could not understand the meaning of :
(Go to the "Save" box (disk symbol in the bottom of the selection box), and name the file that will be the exported DXF data. Select OK to save the file name.)
what is save box?. Disk symbol means?
If you don't mind...
Hello Everybody,
I am sankar.I am using Mentor Graphics Expedition PCB. Now i have some doubt about DXF Export. How to Export DXF?.
I tried to export DXF in Expedition PCB like, File--->Export--->DXF.
But it not create DXF.
Because there displayed one error message.The message...
Mentor Graphics Expedion Tool-PCB
Hello ,
I am totally new to this Mentor Graphics Expedion Tool.
Now I want to change the single pin component pad size.
But i don't know how to change the pad size of component.
and i want to measure dimension of component pitch(likl pitch to pitch, pitch to...
mentor graphics layout tool tutorial
Mentor Graphics Expedion Tool-PCB
Hello ,
I am totally new to this Mentor Graphics Expedion Tool.
I am not getting as how to start and from where to start.
Before I have done my PCB designing in PADS Layout 2005.
Now i am not getting.
There is no user...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
