Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
CloneZilla
Hi Everyone,
I'm trying to Clone M-systems DiskonChip (MD1150-D64) Module to Compact flash (SanDisk 1.0 GB) using CloneZilla. When I mount DiskonChip Module (DOM) to my computer it's showing as Local Disk, When I clone same files to compact flash it showing as removal disk. How can...
Actual In the above picture it isn't because I showed just picture without connection. Please have a look the below pictures which are connected.
Let me know your comments @FvM
Hi Everyone,
Any suggestions "How can I read and write DiskOnChip modules MD1150-D64 with PC"? I already installed Windows XP and connected via Sata to IDE. Unfortunately, PC didn't recognize. So, I'm looking for any bit of information to solve this problem. I'm suspecting because of the...
Thanks FvM,
It help when I connected a 330ohm resister between pin 6 and 8 it shows the current varies between 0.0mA -1.36 mA. Now how to transfer this current to Arduino Uno? How does Arduino UNO will know there is a change in current when the object is moving? Please leave your comment below.
So, I need to connect a 500-ohm resistor between pin 6 and 7 to get 4-20mA current output? Without resistor, I tried earlier it showing only 4mA. But I will try with <=500 ohm resistor
But How to read with Multimeter? Because, If I got the analog output reading on multimeter then I will connect those wires to the microcontroller. What do you think?
Do you think I need to 500-ohm resistor to get 4-20mA current output?
Hello Everyone,
I'm trying to get 4-20mA current analog output reading from the Pepperl+fuchs VDM 18-300 which PNP connection type. But I'm not getting. Do you know why?
Sorry about Novice knowledge on electrical wiring. Are you sure it required an internal connection between "0V and Qa-" . Please see the attached picture and let me know about it.
Hi Ogulcan,
Thanks for reply.I apologize for insufficient information on the data. I added manual and datasheet,
Please have a look and tell me your suggesstions.
I'm using Industrial distance sensor with analog ouput 4 - 20 mA. What I'm trying to do is just interface Arduino Uno with...
Hi KlausST,
Thanks for reply. Here is link of the sensor datasheet
https://www.pepperl-fuchs.com/global/en/classid_53.htm?view=productdetails&prodid=34337
And I would like to interface with arduino uno or any other arduino type.
Hello Okada,
Thanks for reply. Yes, I check the voltage across 4-20mA output and It varies -22.34v to 22.34v. So, I Normally add 250Ω resistor used to get 1 to 5V measured across the resistor, but at this point, I'm not sure how this would connect to an Arduino because I don't know if analog-...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
