Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
yes,
My simulation is slightly different. In that example, the incident plane wave angle is varied and effect of its on s_parameter is plotted. But, in my simulation ,the incident plane wave angle is normal and I need to calculate rotation of polarization versus frequency:(
Anyway, thanks for...
ok,
A linearly polarized field (E field in the x direction) is incident on my structure.My structure is chiral and it rotates the polarization of the incident wave. I want to calculate the transmission coefficient for the right circular polarized and left circular polarized.So, on the other...
dear myazdi83
Thank you very much, but this message is appeared, " No 1d results template exists, Mix 1d not possible".
Do I have to do something before simulation?
Hi
How can I creat new result in CST? for example, I want to know subtraction of two results, for example |S11|-|S22|, are there any ways to define this new parameters? in HFSS, I do this using output variables.
Regards
Hi friends
I need basic information about PNA such as its block diagram and fundamental differece with another network analyzers. Is there anyone that introduce references about it?
Thanks
Hi all
Is there anybody that simulated microstrip antenna using fdtd?
I used the method which described in toflov book for calculation of radiation pattern, but my results aren't correct.
Best
hfss waveport phase
Hi all
Is it possible that two modes in excitation waveport have phase difference?
I want to get circular polarization from horn antenna and I use square waveguide but I don't know how can I adjust waveport?
Best regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.