Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi all.. i need your guide. how to exactly the right way to detect tumor using cst? do we need to assign the material properties to 1st order debye model? am i correct to say that frequency limits 1-2.5GHz for antenna is used to detect the tumor?
actually i have no idea about waveguide mode. i am a beginner user for cst simulation. do u mean that i just simply need to right click at port part and increase the number of mode to 2? "the exist hybrid modes at inhomogenous port 1. this could lead to an inaccurate energy balance. please check...
"some higher propagating modes at port 1 are not considered in time domain calculation. this possibly leads to inaccurate energy balance. consider to increase the number of modes or decrease the upper frequency limit."
this error occur when i set the freq range 0-15. but, when i set the freq...
i've successfully simulate the antenna in frequency range of 0-12 without any warning and error. but as i want to simulate the antenna in 0-20, it couldn't successfully simulate. it has error. what actually goes wrong in my antenna? how to modify the interval of the graph ?
can anyone help me or guide me or give me steps on how i'm going to design TSA vivaldi antenna using cst microwave studio? i've settled certain part of the vivaldi design for txline part n top vivaldi antenna. but, i don't know how to proceed because i didn't found info for the design using cst...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
