Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Friend,
I m trying to program my P89V51RD2 IC using flash magic.. but my ISP kit is not getting reseated when i press the switch, tell what is the problem with my kit.
can ne one tel me how do i share pendrive on LAN.. i m able to share other folders from that pc but not able to access pendrive.. tel me the settings required..
thanks for helping me for programming.
but now i m using avrdude.gui for downloading in the chip.. i m using nex robotics kit + isp programmer. and after executing i m getting following error (pls c d attachment.)
hi..
i m extremely new with atmega 16.. i have nex robotics board and winrar.. but doesn't know how to start program... my code is ready.. do i require to use AVR studio... pls guide me how to use it.
dear friends ,
i would like know that Wat happens to the motor wen d applied load changes.
how does it behaves, does it produce change in current, n can it b measured?
how??
can change in torque be made proportional to the change in current?
Re: serchin for a sensor
hello friend,
even i m thinking of light sensor, but i m not very sure about the response time of it. because the chips are going to pass at high speed n i required to sense each chip.
can you suggest me specific type of light sensor or ne good sensitivity and fast...
Re: serchin for a sensor
thanx for replying
Actually present system is a open loop kind of, operator manually observe whether all six levers r cut n blown safely out of chute, so dat he can go for for next cycle.
but i wan to make it close loop sys where i ll like sense all levers passed...
serchin for a sensor
i m looking for a sensor (proxy or light) it should be able to
measure very fast moving small metal chips of d size
2*2cm, actually its a lever cutting machine n it cuts six levers of above
mention size at a time, then with a air pressure it is blown out through
the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
