Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I want to communicate to the mobile phone using AT command from my Microcontroller[8051] for sending/receiving SMS or Phone calls. Can any one help me.
I have diassembled a hex file by a diassembler and then again assembled the hex file using asem51 assembler. But I found somewhere there is change in code. So I want a Hex file comparer for 8051 which run under windows.
Re: Interrupt Help.
I am using MikroC Pro 8051 which provides vast library facilities for Interfacing many Devices. It can be Available from the following link: -
https://www.mikroe.com/en/compilers/mikroc/8051/
You can check that. There is no need to use 74C922 as per the manual and help...
Interrupt Help.
I have made a simple Program with 7 segment LCD and 3x4 keypad with a
Interrupt function in MikroC 8051 Pro as below: -
//=========================================
unsigned short kp;
// Keypad module connections
sfr char keypadPort at P2;
// End Keypad module connections...
UART 89S52<=>89S52
I am using two 89S52and I want to communicate between them via UART.
I have to 2 Question.
1. Did I have to use MAX232 in this case[communication through wire]?
2. If I use 413 MHz A.M. Modulator and Demodulator[TTL compatible]
Did have to use MAX232 in this case...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.