Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello
i need help for my code in test bench ..
the code is
use IEEE.STD_LOGIC_1164.ALL;
entity ff_vhdl is
Port(a,b : in std_logic_vector(3 downto 0);
cin : in std_logic;
s: out std_logic_vector(3 downto 0);
cout : out std_logic);
end ff_vhdl;
architecture structural...
hello. every one
i have already used DATA Acquisition. but when i use rate Generator. to run i have got a message can not configure my data acquisition (usb-1208ls)
please help ......... i send attached
thanks
HI, EVERYONE ,
can anyone has an idea how to used solenoid by using laptop in data acquistion and control. the idea if i have four different colour all go to the tank but before that there is solenoid in each one . how can i control these colour ...
THNKS
hello,
what is the advantages of using DMA controller in microprocessor system to transfer data from memory of video graphic card to main computer memory .
thanks
hello,
how PWM signals could be used within a vehicle break control system to deliver braking force to a wheel and how control system would convert the braking force into actual PWM control value and i would like improve by a ddition of closed-loop.
thanks ..
compressor can make the audio of more consistent level and eliminate inconsistencies developed by for example when the singer moving closer to and further froma microphone and also the block diagarm we can used diode as the ninju wrote above but i read about this and i found the tremolo...
i think
the compressor can be reduced the out put waveform by reduction amplifier .also this block diagram i posted can be corrected .if any comment please send to this
Thankyou.
if i said any noise that gets induced into the line will be common to both positive and negative sides in order to cancelled when it arrives it is destination .is this can be correct .
which is the method by using differential amplifier to balance line be generated from unbalance...
HI,EVERYONE
how can balance line be geneated from unbalanced audio signal?
also another question how is the noise induced inaudio cable reduced by use of balance line,
i need more information about the above questions,
thank
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.