Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This is the #C code on my MCU below and it will get the signal from the ADC and send to MCU(UCB0RXBUF);
.The MCU will send to RS232 (UCA0TXBUF )and then send to the PC.
I would like to ask that should I modify the code for the conversion between ADC and MCU?And how to modify them?
Please suggest...
Dose any one have experience on using AD7366
.I would like to use it do the sampling part and I use MSP430f2350 to control AD7366.
MSP430f2350 send out three signals.
1.CS
2.CNVST
3.SCLK
and I have connected the DOUTA pin to the MCU pin
And the BUSY have replied but seems the DOUTA pin does...
I use the code below but seems it doese not work and prompt some errors.
Could any one suggest me how to change the codes?
Thanks.
%%Clear all variables
clear all;
%%Variables (Edit yourself)
SerialPort='com6'; %serial port
MaxDeviation = 3;%Maximum Allowable Change from one value to next...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
