Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
More detailed JTAG signals:
Green: TDO
Purple: TMS
Blue: TDI
Orange: CLK
hope this is a little more clear.
I am programming a slow as possible at this point @ 1Mhz
Set up is as follows: (apologies for unconcise schematic, there are two PCB's. one with JTAG header (PCB1) and one with FPGA...
Hi All,
I am attempting to program MPF300T-1FCG784I device using Libero v12.6 (Platnium) with FlashPro 4 programmer (JTAG). However I get the following error when programming.
Error: programmer '01416' : device 'MPF300(T|TS|TL|TLS)' : Executing action PROGRAM FAILED, EXIT -22, refer to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
