Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am newbie here in the forum and have an issue with the control of an engine bridge H (L298N). My problem is that the motor walks not in any sense. After activating the enable (pin11) and one switch (pin10 or pin11) dc motor was supposed to go in one direction, but he remains still. You know...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
