Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the replies, having it rotate back to a index point(solid stop) upon start up would work perfectly in this application.
I thought that I might also add that a potentiometer is not 100% necessary as it does not need to be infinately variable. I am looking for perhaps 8 to 12...
Hi, I am new to this forum.
I am after some help wiring up a stepper motor position controller. I am not even sure if it is possible.. any help would be greatly appreciated.
I have a 6 wire stepper motor.
yellow - common
blue - coil1
white - coil 2
yellow/bk - common
orange - coil 3
red -...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
