Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Well Im waiting on a PIC programmer and really only need to monitor 5 v and 1.2 amps at the moment. So I went with an ATMEGA328P . I created a base arduino and programed it. It seems to be a bit off compared to my FLUKE I am using the internal reff voltage and thinking that may be the problem...
Just a link to my laser cnc project video :) https://youtu.be/9dTS1A2F4j8
I have bin working on it for some time now and the meter is for the controller, i would like it for laser amp setting and power supply volt readings.
the power supply is a 350w PSU moded to supply 12 and 5 v outputs for...
Ty so much, I am new to the hole avr and pic side of things and can't wait till I understand more of the programming side of things. I have compiled hex files before for my gbrl cnc and successfully put in on my arduino. My question is do I do the same thing "modifie the config and compile the...
I have also done the same thing to come to the same wall in that i could not find a hex for the project> i now am sitting here ready to test my design and need the hex to run it all.
i simply want to have the first line read LASER CNC and the secound line have V and A readings>you guys have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
