Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
I have a antenna design obtained from the internet. I have implemented the same in Agilent ADS. As far as I am aware I have followed all instructions apart from where it specifies a via. I used a circle (in the layer called hole). When I check the 3-D view of the antenna the top and...
Hello
I am designing a Audience Response System which includes a capsense keypad, LCD and RF section. the processor comes with a zigbee stack.
Following are the questions that I have.
1). RF and LCD interference problems.
2). Design methodologies for half dipole antenna, Inverted F...
Hello
I am trying to find some information on drives and guiding elements for articulated robots.
Your suggestions will be appreciated.
Thanking you
Roahan
Hi
I am trying to build an articulated robot that is able to carry a two component polyurethane mixing head.
I need some information (on how to start) regarding the design of an articulated robot.
Roahan
Hello
I am learning PERL programming and I have been using verilog for a while now, I am still unable to learn on how to write a PERL script for RTL level design. Any insight on this would be helpful.
Hello
I am looking for a book that deals with basic circuit analysis, and also one that deals with Analyzing a network using the Z parameters, Y parameters and ABCD parameters respectively. Your help will be truly appreciated.
Roahan
microwave engineering freeman
Do any of you happen to have the link for
Microwave Engineering : 3rd Edition by Pozar.
Your help will be truly appreciated.
Re: 2's compliment
One way to do it is the following :
1. Using an X-OR gate (it is a controlled inverter) pass logic 1 into one pin and the data (say pin B) in the other if you want to invert the data. If you pass logic 0 then no inversion occurs.
2. Then using an adder circuit using add 1...
Hello,
In a flip flop based design, when considering the clock period, we need to consider three aspects
1. Clock to Q delay.
2. Time taken by logic
3. Setup time
In a FF-based design Clock-to-Q delay and setup time are overheads and need to be addressed at all stages of the design...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
