Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I need help.
I have no idea how to build this one. I need a circuit that can read a voltage drop of 9V or below and flip on a relay, than turn the relay off when it reaches 24V to 30V.
The voltage input source is 24V which could be reduced if necessary.
Any help is appreciated.
Thanks
ROB
Thanks once again.
Can you point me in a direction of creating one. I'm some what of an amature at this. I've been learning as I go long. You know what I mean and haven't done bad so far.
Thanks
I have 24VAC(input) being stepped up to 115VAC(Output). My oscillating circuit output a square wave before going to the stepup transformer. I trying to solve this problem be converting the square wave to sine before being stepped. By-the-way, the amperage is some where near 80AMPS.
Can anyone...
pulser
I like to start by saying that "I'm a AMATURE". Now that's out the way. I need some help.
I have effectively designed a water fuel cell the splits water into Hydrogen and Oxygen. The design works just great, but I need to send a pulse to the electrobes so that I can tune the device and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
