Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In Embedded Systems we use SMD(Surface Mount Devices) which we use packages such as 0402,0603,0201 etc and has a tolerance of 1%,%5 and power rating of 1/10W,1/16W.For Capacitor has voltage rating of 10V,16V and 25V.
What is the significance in tolerance of i.e the same value with different...
hi cks3976
we probed signals at the i/p and o/p of the buffer, the problem we are facing is that the acknowledgement bit is not going to low. the waveforms captured is shown below.
i/p of buffer:
o/p of buffer:
The pull-up resistor at the processor side(i.e., at i/p of buffer) is fixed to...
We are using a buffer for I2C interface signal's voltage level translation. Here our I2C host is OMAP3530 which is of 1.8V signal level and device is TVP5150AM1(video ADC) which is 3.3V signal level.So we are using TXS0104E for voltage translation which also supports I2C signals...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
