Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the thing is i am not using UART i made my own protocol which works perfectly with wires
Basic idea - baudrate either 2400
1)idle bit =0
2)start bit 1
3)manchester coding
connections
MCU1 MCU2
pin D3 -> rf-tx -> antenna...
connections r fine but still not working receiving 0x00 all the time. baud rate is 1200 bps (working for wired though). am i making any conceptual mistakes???
i have written my own coded transmission protocol (manchester) it is working perfectly with wires. i made sure there are no continues 1s or 0s. can i, now ,send the output directly into the tx module's data pin??
Hi everybody i am new to rf module interfacing (using AVR) and am not being able to implement it,Can anyone please suggest some solutions or guide me on how to make it work.
Circuit info
avr tx to transmitter module(433mhz)
receiver module to rx pin
i dont know what changes to make and really...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
