Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
So I've imported a stp file model into hfss12. File imports fine but having problems with the meshing. Does anyone have experience in doing something similar? Any help would be greatly appreciated.
Hi everyone
A buddy of mine has a working DNG which shows promising results... we would like to test the material further with some type of aircraft models and know that they might be hard to come by
Any suggestions on the laboratory set-up ??
We're planning to test using 2 x-band antennas/...
antenna probe feed
I've designed and now fabricating a probe fed antenna, and now I need to solder the probe and female feed for the coaxial cable. I'm lost right now, dont know what female coax feed or probe to use.
Please help
I've designed and now fabricating a probe fed antenna, and now I need to solder the probe and female feed for the coaxial cable. I'm lost right now, dont know what female coax feed or probe to use.
Please help
I'm trying to make it work at 3Ghz then I'm making a slot around the center in the shape of a "U". The slot is should help the bandwidth. I read about it on an IEEE paper.
It's called " Single-layer single-patch wideband microstrip antenna" by T.Huynh and K.-F. Lee
They claim the the slot...
Thanks for replying
I've set the box to Rad1 and changed the coax to .7 mm for core and 1.6 mm for the dielectric but the results are still ugly.
I've posted a new file with changes
I'm having trouble again..
Everything is validating and running well but not so good results. Can someone take a look at it.
See attachments..
One is on Duroid6010 and the other on Duroid5880
Please help
hfss11, antenna design
Thanks guys. I got it now. :) I'll let you guys know how it turns out. Eventually I'm going to put a "U" shape slot in the center hoping to increase the bandwidth.
coax fed patch antenna design
This is my first time using HFSS. I've already made the 3d model but not sure how to set the center core of the coaxial as a terminal port.
Suggestions?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.