Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: What are the differences between doped MOS and nondoped
Thanks Erikl.
I think the non-doped MOS might refer to the native MOS, with nearly zero threshold voltage, while the doped MOS refer to normal MOS.
Hi,
I had a question about the PNP transistor array:
Those pnp transistors are used in the bandgap reference circuit, and when the pnp array is laid out, should I add double guard rings to them? I mean, is this neccessary?
Thanks.
Thank you for your reply!
But the double guard ring is not for just nmos or pmos. Actually, I only used single guard ring for them(eg. ptap ring for nmos, ntap ring for pmos), while the double guard ring is for the whole module such as opamps.
So, under the above situation, which sequence of...
I know that guard ring is used for shielding. Ptap guard ring is used for NMOS and connected to VSS, while Ntap guard ring is used for PMOS and tied to VDD.
But I do not know how to draw a double guard ring?
1,Should I put the Ptap guard ring inside, and Ntap guard outside, or vice versa...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
