Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
To set the Xport GPIO state you must send a 9 byte datagram where byte 0 is the command, bytes 1-4 are a mask, and bytes 5-8 are the new state. Below is sample code for MATLAB which sets all three GPIOs to active. Pages 78-80 of the User Guide give details about the datagrams.
xportIP =...
Hello! I am attempting to use the GPIOs on the Xport to control a set of relays. However, I have not been able to figure out how to change the state of my Xport's GPIOs.
Using the DeviceInstaller I am able to change the configuration from Active Low to Active High, but I am not able to change...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
