Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For now, I am using old version Protel; Protel98 to design schematic and PCB. If I install new version of Protel, I mean Protel DXP2004 and I make schematic using it, can I open the schematic file using old Protel98?
Thanks for any input:)
A few quistions about nokia 3310 and sms receiving
I think you have to add voltage level converter IC such as MAX232/3237, not to connect your mobile phone and uC directly
Usually if a module has TCP IP stack, it also has PPP protocol, are you sure your MC35i doesnt have PPP protocol?
If it doesnt, you have to write your own ppp code.
89C51 and GPRS
Hmm.. if your GSM module has built in TCP IP stack, I dont think you need to build Tcpip program, just order your uC to control the stack according to Enfora hardware manual.
Mostly,GSM modules have been implemented with built in TCPIP stack.
89C51 and GPRS
what GSM module?
All GSM modules have their AT-command for controlling GPRS.
I've tried 2 GSM modules, one is Sony Ericsson GR47 and the other is from Telit Gm862. I use hyperterminal to connect GPRS.
I suggest you try using terminal program before interfacing using uC.
Re: help plz zzzzzzzzzzzzzzzzzzzzzzzzzzz(about mobile interf
I think you should check this one:
https://pinouts.ru/CellularPhones-Nokia/nokia_5110_6110_pinout.shtml
There is nokia 6310 pinout, you should pay attention to pin number 7 & 8 (DLR-3) as they're tx and rx and GND as well. Dont...
sony ericsson gr47 gprs module
No, I don't have dev.board for GR47. I don't use all GR47's functions so I think it's not necessary and it's quite pricey as well.
I use GR47 dev board myself.
What kind of project you want to make using GR47 ?
script gr47
For downloading or deleting script using M2Mpower IDE, you should connect GR47 via UART1. UART 2 for debug.
To do it with M2mpower IDE:
-Make sure your GR47 connection with M2mpower IDE works well.
-Press "Stop Running Embedded Scripts From StartUp"
-Also " Stop Running Embedded...
Problem with uC!
I think there is must be a mistake with your ISP header on your PCB.
You should check this one:
http://www.atmel.com/dyn/resources/prod_documents/isp_C_v5.PDF
FYI:
TCK --> SCK
TDO --> MISO
TMS --> RST
TDI --> MOSI
m2mpower ide
Hi, I'm doing my project using Sony Ericsson GR47 GSM/GPRS module. Firstly I'd like to learn how to use UART in GR47, especially UART 1 and UART3.
I've written simple program(scripts) using M2MpowerIDE to control UART3, but nothing happen at all.
I also checked UART3 pin(Tx and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.