Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I only want it to execute once, that's why I used the if statement and not while loop. Also arduino sorts of makes things simpler for its users, so mainly only two methods are used; the setup() where you mainly initialize your pins or, want a block of code to run once. And also loop() where the...
Basically I made the circuit so that when pin 11 is connected to ground, 1 is sent to a serial port. When I run the simulation on proteus, the RX pin of the arduino blinks, but nothing is shown on the display of the virtual terminal. I have tried do many things, but nothing's working. The...
Please I tried running a simulation on proteus. An ac source is connected to a step down transformer which is then connected to a bridge rectifier after which the dc output is filtered with a capacitor. I connected an led to indicate if the current was flowing , but it keeps bringing about these...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
