Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi;
I am using ATMEGA16 and interfacing three analog sensors with it.
Initially I just interfaced only one sensor ,and did required programming in 'c' in codevision avr compiler.
for one sensor i am getting the required output on LCD but when i did the same programming with two sensors...
Re: air content analyzer
hey;
For my academic project,I am trying to build an 'air content analyzer' in which I want to display the contents of gases(co2,co,lpg) in percentage on lcd
I am using ATMEGA16,and analog sensors,
adc output is stored in adch,adcl registers,which is 8 bit...
Re: air content analyzer
First of all thanks for you concerns,
so,which sensor would serve the purpose,
---------- Post added at 23:16 ---------- Previous post was at 23:14 ----------[COLOR="Silver"]
---------- Post added at 23:20 ---------- Previous post was at 23:16 ----------
I...
hello;
i am going to build a an air content analyzer using ATMEGA16.
This device is going to show how much percentage of certain gas is present in air(eg percentage of co,co2,lpg)
For lpg ia m using a sensor in MQ SERIES **broken link removed**
Gas is measured in ppm unit,if I want to...
hello,
I am using atmega16 which is having inbuilt adc,
I have use 8051 before .....i dnt know much abt adc in atmega16
so can anybody give some small code with all initializations,,,,just to increment my prog skills with atmega16(c code)
In a datasheethttp://www.sparkfun.com/datasheets/S...etric/MQ-6.pdf
there is one spcification PRE-HEAT TIME=48hr
how does it matter while designing detector
can anybody plz tell....how can we get constant output across RL
In a datasheethttps://www.sparkfun.com/datasheets/Sensors/Biometric/MQ-6.pdf
there is one spcification PRE-HEAT TIME=48hr
how does it matter while designing detector
can anybody plz tell....how can we get constant output across RL
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
