Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When sending data to LCD you should keep in mind that to LCD meaningful data is ASCII characters.
But you have used unsigned int which is a decimal value.
So you should make a conversion before sending it to LCD.
the conversion is as follows:
if X=100;
lcd_data((X/100)+0x30)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.