Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply .
Any tips on improving the gain (Currently I am working on an Inverted F PCB antenna and a gain of about 4.3dBi). Also any points to consider while designing a dual band antenna considering that we require high bandwidths for the two resonance frequencies.
It is highly dependent on what you are using the antenna for. In case you need the antenna to be used with base station , it should be omni directional and this response is not good , whereas if you need it places where a more directional response is needed then this will be better . Apart from...
Currently I am designing dual band IFA antenna for GSM900 and DCS using CST. But I am finding it really hard to get the required amount of bandwidth. Can anyone share techniques by which I can increase the bandwidth ? Thanks in advance.
I am trying to design a L match in my antenna to tune my antenna to a particular frequency. I am using this configuration.
I have made the inductance and capacitance using LumpedRLC boundary excitation.I am also adding the screenshots of my current setup
The L match does not tune my...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
