Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by rashdriver

  1. R

    Need driver circuit for electrical load for practice

    Hi everybody, Iam in need of various Driver circuits for simulation purpose. If you have the output wave profile too, then its very much useful for me to crosscheck the result with your reference wave profile. Expecting more response from our group. Thanks a lot.
  2. R

    Cadence PCB Editor output file generation

    How can i draw the arc with specific arc length? thanks for your reply
  3. R

    Cadence PCB Editor output file generation

    Dear everybody, Any one help me to solve the issue please. Rashdriver
  4. R

    Cadence PCB Editor output file generation

    Dear sir, I had sent files to BRGD klavs@rommedahl.dk, klavs@rommedahl.dk and BRGDklavs@rommedahl.dk Because yesterday i sent mail to first id. If you are not receive that kindly give me some other id. Thanks with Regards, Rashdriver.
  5. R

    Cadence PCB Editor output file generation

    Dear sir, I am very thankfull for your valuable help. Kindly check my design configuration and direct me to get Silk screen, Paste mask and solder mask gerbers. File path:Demo/PCB/Allegro/Demo.brd Find the design file from here as well as mentioned mail ID. Thanks with Regards, Rashdriver.
  6. R

    Cadence PCB Editor output file generation

    Till now iam not able to generate sucessfuly. Kindly help me. Thanks
  7. R

    Cadence PCB Editor output file generation

    Hi, Thanks a lot for your reply. I did the things upto my knowledge. kindly correct the mistakes and guide me for unknown things. I configured device type as Gerber RS274X. I defined the photoplot outline similar to board outline. I tried to configure apertures without rotation but...
  8. R

    Cadence PCB Editor output file generation

    Sorry for delay. i tightly engaged with official work. Dear lhademmor, i tried to follow these sequence but failed to generate SST file. i cannot able to realize where i did mistake. here i provide the snaps for these process. This is the board design with top and bottom layer. After...
  9. R

    Cadence PCB Editor output file generation

    pcb assembly manufacturer Dear Friends, I am new for PCB Editor. I designed a PCB for some project and cross checked the dimension. For conformation i want to make that PCB physically and test the board. Now i created artwork files for conducting layers. subclass creation, Display match for...
See more

Part and Inventory Search

Back
Top