Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
As u can see (from the equations you were given) output resistance is found from small signal model (since it depends on small signal parameters).
The formulas you got are aprox. and good in most cases, but u should solve your small signal model for complete solution (in some cases - as...
Well ... the capacitor that kot_b mentioned is decoupling for supply. It is supposed to supply high frequency currents into supply pin of MSP. When processor is running it should be used, but can't be sure if it is absolutely necessary for programming purposes.
I would put it, to spare myself...
msp430 jtag programmer
I was using TI programming tool ...
As I recall not all of MSP430F devices require pull-down resistor on TEST, but putting one won't hurt.
Depending of your programming tool capabilities you should consider supplying power to target from jtag or connecting target's...
windriver cypress fx2
If u still need this ...
Find evaluation of WinDriver from Jungo (www.jungo.com).
It comes with examples. They even have "special" support for Cypress (but it is just a few functions you could write on your own ... still, less coding less bored :))
Do you already have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
