Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Let me tell you how moving averaging techinque is implemented.
First a window on certain no. of samples (in your case -16) is taken and the samples are averaged over this window.
Then this window is moved over to the next window ( 2 to 17) and so on.
Hope it helps..
Re: 12V to -24V
I could think of one possible solutions to ur problem. You can use DC-DC conveters for doing this sort of votage level translation. But they are somewhat costly but very effective.
Visit the site of micromax for such converters
I was reading ur posts on 2 ground issues.
Have observed optocoupler circuits wherein the gnds of both the input and o/p ports are isolated. Is this done to reduce noise propating on the ground line.
What will happen if both the grounds are shorted?
:?:
Slave address happens to be 0A0 and the firmware is sending the right address when observed on the CRO.
Added after 1 minutes:
The port pins needs to be configured for either open-drain or push-pull.
:idea:
Hello all,
The 24LC64 does not generate acknowledge in the ninth clock after control word is sent. The sdata line does not get pulled down by the device.
I have configured the uC port pins of sdata and sclock in open drain also
Kindly provide your suggestions.
:|
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
