Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi..
I would like to know how to write a fuzzy logic based C program for PIC18F4431 microcontroller ?
I am using MPLAB IDE for programming the PIC18F4431 microcontroller and i am using mplab-C18 compiler with it. My project is to control speed of BLDC motor using fuzzy logic.
So, Any sample...
thanq u every one for ur help,the main problem is with hardware,before connecting led we put a limiting resistor right,i kept a 470 ohm,this used to draw a huge current so the mic used to get rese every time as its is getting overloaded,so now i kept a limiting resistor of 1k,it works good,so...
this is my assembly prog to blink rd2,rd3 bits of 16f877a,after building and dumping it into mic..it does get started blinking,even i turned off the supply and on it again,i have to reset the mclr pin with ground then led blinks with voltage flucations......
but if i bump the prog written in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
