Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, friends
I am using two wire RTD Pt 1000, in my circuit. Can any body give the signal conditioning circuit for this two wire RTD Pt1000. Please send me the circuit as early as possible. I am waiting for ur response.
Thank u so much.
Please help me regarding VHDL code to interface ADC0804( the 8-bit ADC) to FPGA .
please send the VHDL code as early as possible.
I am waiting for ur reply.
pls its urgent.
with regards
Nagaraj
Hi friend, thanks for ur reply
Off course, i don't want to switch the relay within the particular time period. I want only to just on the relay at particular ADC value, if it lower than the ADC value, then the relay should off, again it should on when ever it reaches the ADC value. Can u pls...
Hi friends i am reading data from ADC0804 which is connected to the 8 LEDs.I need to control the ADC data at particular value, for that i introduced mechanical relay. The following program tells you the same. I am using FPGA spartan3.
Here my complaint is i am unable to ON and OFF...
Dear friends,
I want interface the mechanical relay with FPGA. Can any body help me. Please send me the circuit. I want use the following things: MCT2E, SL100 and IN4007. I am waiting for ur response.
thank u.
with
regards
raj
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
