Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
Just like IRFZ44N an N Channel MOSFET
I want to know about the matching commercial P Channel MOSFET number
Please help me in finding it !!!
Thanks . ..☺️😊
Hello,
Here is a Tsunami Wave Trigger microcontroller Board applicable for musical gadget designing
Is it possible to change the pitch of a wave in sequential (step by step) or random order ????
hELLo !
I am trying to design a simple Triggering model as shown in figure attached . .
P1 - P8 are the piezo electric sensors connected to the input of a microcontroller board which has an external memory card module attached with output for audio . . .
Now i want to make a system...
Hello
Which type of electromagnetic wave is best for audio wave transmission and what type of transmission system is best ???
What frequency range we should consider ?
Hello All
I want to design an ultrasonic sensor system with HC-SR04 Ultrasonic Sensor but without use of Arduino or any microcontroller !!
Is it possible ??
If yes then how ?? please help me with proper circuit configuration !! Thanks :):)
Let me go through the stuff !! thanks
1620259366
But
But size here is big enough and not satisfying the condition of 350 mA physically . . . . Here its like 1.5 or 2 A . .. then how come ?? Please elaborate ! thanks
1620259647
Ya but here its showing 20 ohms . . . May be multimeter or some...
Ya ya with no power nothing. . . . Just a direct measurement between 2 terminals . . Anything I need to do other other this ??
Size I hv to check for each side . . . I didn't take .
Power
1620154594
Yes that 250 mA generally installed in small tape recorders where 6v supply were also there...
Hello Everyone !
I got this transformer in picture from my pal . . . It was installed in an old model cassette playing music system with a cassette loader carrying a stereo head , a 12v old motor , couple of leaf switches and an audio amplifier board with IC 4440 . ...
Is it really something we need to place inside the flask ??
in this demo https://www.youtube.com/watch?v=wOrwa6Mo4VM
the didn't anything like that . . . please check this link . . .
ya ya firstly it was working with I metre wire very efficiently. Even today I installed the motor in the vicinity of the power source and its working as usual.
and ya the motor seems like it's trying to rotate the shaft or say its try to work with the available parameters. But its too dull to...
Hello
i am using a 12v 7Ah battery to run a motor with a fan attached to it. Problem is the decrease in speed or say load handling capacity when I am increasing the wire length. I need to run a 7 mtr length of wire but in 5 mtrs only I am facing the problem . . .Normal LED lamps are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.