Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by rajabi_u

  1. R

    Help me model synchronous generator in Opera 2D

    Hi Any body work with vector fildes\opera 2d software? I want to model synchronous generator with this software;and needed to help. I want to know how can input torkque and out put was voltage? how define ploss(power losses) into this software ? any examples were solvet by it please share...
  2. R

    hard problem: "feed forwards"

    1)what is feed forwards? 2)what are 3 inputs and 2 output for feed forward? 3)advantage voltage source from curent source? 4)what is mM=f1(imR,...); 5) isq=f2(imR,...); 6) isd=f3(imR,...); 7) usd=? 8) usq=? 9)what are names of each controller?and why did use 3...
  3. R

    Need help with plotting V and I in Matlab code

    Re: matlab help hi everey body knows that . but i want to know :can write a progrom for same this problem ,that its progrom solve the that formola; are any body know this please help me to write the that program ok thanks regards
  4. R

    Need help with plotting V and I in Matlab code

    matlab help hello all; iwant to plot" i " versus "v" ;that i is current abnd v is voltage; then formla is bellow: V=[0:.01:600]; (.317V)^2=[((1.5/I)+(1.5*I)-(.27*V*I))^2]+[((1.5*I)+(.27*V*I))^2]; please help to plot(V,I); ok thanks
  5. R

    average model of two transistor converter

    hi all; i need one model: "average model of two transistor converter" thanks all
  6. R

    How to simulate a IPMSM motor with Matlab?

    Re: matlab program hello "ipms" is motor ;but i want to learn "s function" . regards
  7. R

    design double switch forward

    double switch forward converter Hello v_c; Thank you very much from your answer, Can you give more becase for design transformer and control by IC;i have problem. Thanks a lot of. Regards
  8. R

    How to simulate a IPMSM motor with Matlab?

    Hello all; I want to simulate a "IPMSM" motor with "MATLAB" software but I donot know how I should write a " s-function" for this. please help me about writing " s-function" thanks very much
  9. R

    design double switch forward

    double two transistor forward hi all can you help me? i want design double switch forward that input voltage was 230(+10%;-15%)v: output voltag was 12±1% v;output current was 20A ; this switch should be controlled by IC SG3842; if you knew which book is good for this desine ;that is very good...
See more

Part and Inventory Search

Back
Top