Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
you can use current transformer for current sencing in microcontroller you can program the value on which you want to over load.
or you can connect over-current relay with it has switch N.O(normally open) and N.C (NORMALLY CLOSE) YOU CAN USE These
switch for over over load
hi,
first you have knowledge about spi interface
then u choos microcontroller i like atmega16 it has spi interface
you have to read mcp2515 manual you also interface mcp2551 with mcp2515 through pin rx_can(pin 2) and tx_can(pin1) to mcp2551's pin 4(rxd) and pin 1(txd)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
