Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your advice. You really expect on this.
It look like the electrolyte capacitor for voltage regulator cause error. 25V 47uF and 16V 100uF.
from the manual or user guide, the PICKIT 2 shut off if current exceed 100mA, how to make it able to last with higher current?
No wonder many custom made do lite version. the programming on the GO without PC is rarely use.
I done create one, but able only to program naked PIC. if connected with board that can program PIC using PIC KIT 2, it come out with VDD level error or VDD must 3V to erase and program(if connect to...
thank you for your reply.
Look like I can not get to PCB workshop since they not allow using the equipment in there if got SMD part. I think i stick with DIP/TH.
im within Malaysia, someone here has done that with BS250/170 but someone post that BS250 cause trouble, which i look for another alternative component.
I do not have any rail-Op-Amp yet. currently looking for MCP6002(2 Op-Amps) at Farnell but if got another best alternative also good since...
can someone guide me what good Through Hole P-channel Mosfet can replace bs250 and N-Channel bs170?
I can not get BS250 on my area. From reading the BS250 cause many problem. Any other alternative?
for bs170 i using 2N7000. If anyone encounter any problem with 2N7000 please give your...
do anyone know if this inductor will work on PICKIT 2 circuit?
MURATA POWER SOLUTIONS - 13R684C - INDUCTOR, 680UH, 10% 0.42A TH RADIAL:
https://my.element14.com/murata-power-solutions/13r684c/inductor-680uh-10-0-42a-th-radial/dp/2062701
wall power brick is simpler but not really portable. The servo motor at 4.8V no load = 100ma, Stall = 270ma, guess at 5V it not really far the different.
based on your picture u just disconnect green wire and put back red wire to pin 6 when u need LA?
can bypass Pin 6 to make it +5v?
so AUX...
Hi wp100,
thank for reply
do you mean pin 6 for output/target board?
can make disconnection pin 6 and connect to +5V connection by using switch without using any addition component?
can I increase the current by using Y-Usb connector which required 2 port usb from laptop/desktop? Max supply...
Hi,
anyone has try using USB power PICKIT2 alone to drive/run PIC with some Sensor and 2 servo Motor without using external power?
Can this be achieve? What modification need to be made to run only using usb through PICKIT2 to run some sensor and motor?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
