Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am designing a transmission line and have decided to use AAAC 'Greeley' dual bundled conductor on my desired T/L. The subjected line under consideration has Copper installed which will be replaced.
I am unable to find the distance which should be kept between the two bundled...
Hello,
I am new to the forum and don't know if I am posting it in the right section.
I am working in a non-profit organization which aims to provide sustainable energy to the rural areas in my country.
One of the challenges we've been facing is how to provide more battery time to customers...
Hey,
I am about to make my third PCB and a friend proposed me to look for the Hydrogen per oxide chemical for etching rather than going for the Ferric chloride one. I previously used Ferric Chloride but after using it to make one PCB I had to dispose it off. I read the procedure for the hydrogen...
Hello,
I am a making a monitoring unit which will take in input from a user (current) and will sample it and will give me the output.
Now I searched the internet and I understand the part where I will have to decrease the voltage value so I did using a voltage divider circuit and I getting a 5V...
Hi,
I just finished of with my development board. I'm using Proton 7 for compiling and the problem is that the led matrix I've connected with the zif adapter to toggle isn't working. I checked all the points of testing and it's working fine. I tried my chip on my friend's db and the led...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.