Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The datasheets are exactly the same...
I'm applying the schematic the datasheet said exactly, the difference is only the 16.5V supply voltage and the PSM N0R9 MOSFET.
Hello
I'm trying to drive a BLDC motor with Hall sensor, whit an Allegro A3930 IC, everything is working good the only problem is that the current is more than what it should be, the no load current of the motor I'm using is 0.2A - 0.3A but the current is 1.5A now.
I'll appreciate your help...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
