Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The lines influence the impedance seen at the input of the voltage multiplier in a significant manner (even though they are both physically and electrically small).
I wanted that impedance to be as close to reality as possible, so that I would be able to design a good matching network (so...
In the case of a TV signal I would say the best antenna would have a high gain and a bandwidth large enough to cover the intended frequency band
Regarding the components, I think you will have to use SMD parts because typical components are hard to find
Also, I would advise you to take into...
5uA is the amount of current that the sensor node consumes while sleeping (this value corresponds to the sum of the quiescent currents, and was based on datasheet information)
by the way, feel free to ask more questions
Hi everyone,
In my MSc thesis I have developed a passive wireless sensor node that harvests the energy it needs from a nearby RF power source (basically just like passive RFID tags do).
I would like to share this with you :-D
Main characteristics: battery-free, ASK demodulator, backscatter...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
