Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello there,
i want to understand if i interface the eeprom to 8051 then will it be a von neuman architecture.
can anybody help me to understand the basic of this.
hey,
i am working on friendly arm more then 3 months. i have a little exp. on it.
first of all download the arm linux gcc compiler given in the kernel guide.
download it from arm sites.
hey
if you have an interest in linux platform(Debian) and want to make GUI based programming go with
Beaglebone
RaspberryPi
friendlyARm
they are used in many applications and ease to use.
driving ac motor and control speed
hello everyone,
i want to control single phase ac motor controlled by pot. or by using Mcu.
can anybody give me circuit diagram or idea....as i goggled but not satisfy
hello,
how can i do it with phase angle.
i have an pdf in which it describes the control the ac motor speed by VFD..(variable frequency drive)
here is the link
https://www.academia.edu/7556219/SPEED_CONTROL_OF_SINGLE_PHASE_INDUCTION_MOTOR_USING_MICRO-CONTROLLER
hello everyone,
i want to interfacing the single phase AC motor to Friendly ARM.....but before that i will do it on my 51 or avr kit....
i also want to contorl its speed......
can anybody help me for this????
thank you..
helo everyone
i am woring on raspberry pi same as ardunio board diff. is only it work on linux platform as raspbian OS in it version of DEBIAN.
i have wrote a gps code in it to receive the $GPGGA data only;;
[CODE]
//code for reading the gps using raspberry pi
#include<stdio.h>...
sir i understand
.i received the data within 15 seconds but my question is how can i disable those data which i dont want.
i have SIRF commands but nothing happens when i command it.....commands has commented above my post
but i want to stop or disable the data which i dont want.
how can i do...
Re: GPS MODULE not gives data according to my location
hello everyone
i have the same module as arun_9998 .my problem is i received more data format viz.GPGGA,GPGSA,GSV and many more but i want only one as GGA format.i tried input commands in flash magic with <CR><LF>.
but nothing happened.my...
hello,
First of all you see weather your gps module receive in binary format or in NMEA format??
after that if there are some input commant of your gps receiver to configure the gps module....although the MCU u are using can able to interface the gps receiver...even 8051 can do that...
hi
i want to interface my gps board with raspberry pi......now i got the data when connecte to hyper terminal.
how can i interface this
can anyone give my some idea.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
