Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ICD2 revisited??
Finally, I built my Stolz ICD2 (serial version) but I get a "ICD0286: Unable to communicate with ICD".
All of the I/O data lines are "alive" (they change voltages when I try to connect) .
I´m using a F877 with BL010101.hex.
I´ve already disable FIFO buffers.
I cannot download...
Hi,
I have the same problems:
Connecting to MPLAB ICD 2
...Connected
ICD0286: Unable to communicate with ICD
ICD0082: Failed MPLAB ICD 2 operation
I think that ICD2 is "almost alive" because if I turn it off it doesn´t say "connected" anymore.
Are you sure a Target PIC is needded?
I cannot...
ftdi232rl buffer disable
Thanks people.
I already have several "easy programmers" (serial and parallel).
Now I need an "simple emulator", I mean, an ICD2.
Stolz´s ICD2 Clone (**broken link removed**) seems to be simple.
Questions:
1) Must I programm the Clone ICD´s PIC with the firmware...
ftdi 16f876 schematic
Hi jaydag71!
I´m also looking for a "good ehogh" ICD2 clone. I don´t care if is USB or serial.
Have you build your ICD2?
Thanks
Added after 22 minutes:
Note:
I was checking different ICD2 versions ("stolz", "nebadje", "MCUServer",... versions).
All of them are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
