Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am using ic5141 usr5 and calibre(ver.2009) but i have a problem.
when i start cadence(icfb &), i see following messages.
i try to solve this message but i can not that.
what's the problem? (the pdk is ts35pm)
I confirm that others are not blinking.
If a line property in the initial file have the property set to blinking, what is method
which change a property?
Added after 4 minutes:
Yes. I didn't see any errors or warnings in the CIW or the shell(C-shell).
For reference, I installed it on...
awd waveform blinking
I installed and ran the IC5141.
I made a schematic and simulated it using spectre.
And then, I checked simulation result using AWD window.
But graph's line flickered which was on and off.
I try to modify it but I can't solve it.
What is problem?
lmgrd ic5141
I have a follow problem. So I want to your good solution!!
# lmstat
lmstat - Copyright (c) 1989-2004 by Macrovision Corporation. All rights reserved.
Flexible License Manager status on Sun 2/8/2009 02:47
License server status: 1111@host
License file(s) on host...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.